Those who buy either of these headphones are in for a treat. Our reviewer didn’t hold back in their assessment of these cans’ ability to fully realize every detail of a recording, noting their “warm and rigid bass, a midrange that dips close to the ruddy colors of analog tape saturation (without sacrificing an ounce of detail), and a laser tight response up top that helps illuminate vivid clarity and granular instrumental texture across the board.”

Preferences for the length of headphone cables vary for portable users, especially depending on where you prefer to wear your device: a backpack or a pants pocket necessitates a longer cable, while you'll opt for a short one when wearing a player on a neck lavalier or an armband. But a cable length at either extreme need not be a fatal flaw: extension cables can lengthen those that are too short, and cable wraps can tighten up ones that are too long.
Cable dressing and length: Most stereo headphones have just one cable, usually attached to the left earpiece (sometimes called single-sided cabling). Some models -- and all earbuds -- use a Y-cable that connects to both earpieces (double-sided). The actual cable plug, meanwhile, is usually one of two designs: a straight I-plug or an angled L-plug; the latter may be useful if your portable player has a side- or bottom-mounted headphone jack.
Today they are typically used only in in-ear headphones and hearing aids, where their high efficiency and diminutive size is a major advantage.[20] They generally are limited at the extremes of the hearing spectrum (e.g. below 20 Hz and above 16 kHz) and require a better seal than other types of drivers to deliver their full potential. Higher-end models may employ multiple armature drivers, dividing the frequency ranges between them using a passive crossover network. A few combine an armature driver with a small moving-coil driver for increased bass output.
I’m looking for a pair of studio headphones but I can’t decide. I want to produce dance music on these headphones since I don’t have $$ for monitors. The three headphones that I read most positive reviews about are the Shure srh 840, GMP 8.35d and the KRK KNS-8400. I read the GMP 8.35d are the best but I can’t test them since no shop sells them in my area.
The company is well known for bringing noise-canceling headphones to the general public — the QuietComfort Acoustic Noise Cancelling headphones were released in 2000 — and since then, it’s only continued to churn out industry-leading noise-canceling headphones. Its most recent iteration, the Noise Cancelling Headphones 700, might just be the best noise-canceling headphones, ever.

If you have a bass problem you could find a filter of some kind that cuts the low bass. Some bass controls can do that. I haven’t found a music genre that totally lacks strong bass, although “acoustic” sometimes doesn’t have strong bass. Mainly, you should make sure your system is matched properly with amp and headphone, so the different frequencies are in balance. Then you will have better luck with different music.
Gaming headsets are headphones that have a microphone attached and allow users to speak to other people and hear them with the same device. In fact, gaming headsets have other practical applications as well. You can use them in business or personal situations when you want to speak to people on a computer using a video phone program or social media chat room. Although these work for music applications, they're more suited for conversational clarity.
×