I will post some comments. If I forget let me know here. My main reason for ordering was the old pads on the 1350 wouldn’t make a good bass seal in colder weather, and Beyer has upgraded the pads on both the 1350 and the T51p, so I’m hoping for a better seal this time. I don’t know of any headphone that size that ‘s as accurate and detailed as those little Tesla models, and the carrycase is icing on the cake.
The DT770 is fine – not basshead, the COP is the same size and configuration as the 770, and both of those, large though they are, are “tighter” built so they feel less clunky than the M50. But the biggest problem for you is that the smaller headphones under $200 almost all have a steeply rolled-off treble, which is trouble for the more refined type of music. One possible exception is the Harman Soho.
Those who buy either of these headphones are in for a treat. Our reviewer didn’t hold back in their assessment of these cans’ ability to fully realize every detail of a recording, noting their “warm and rigid bass, a midrange that dips close to the ruddy colors of analog tape saturation (without sacrificing an ounce of detail), and a laser tight response up top that helps illuminate vivid clarity and granular instrumental texture across the board.”
In the professional audio sector, headphones are used in live situations by disc jockeys with a DJ mixer, and sound engineers for monitoring signal sources. In radio studios, DJs use a pair of headphones when talking to the microphone while the speakers are turned off to eliminate acoustic feedback while monitoring their own voice. In studio recordings, musicians and singers use headphones to play or sing along to a backing track or band. In military applications, audio signals of many varieties are monitored using headphones.

I will get to these today. Just imagine the sound you hear is a line stretching left to right, with bass at the left and treble to the right. Now the line is tilted toward the right so the bass is higher (stronger) and the treble lower (weaker). That’s an example of getting darker. It’s not a perfect analogy, since any complex combination of sounds or balance is possible, but in general when something sounds darker you’ll have less influence of the treble.
We run every pair through a rigorous testing process over several days or weeks. That includes playing them in all sorts of scenarios — be it on a bus, in the listening room, or at the office — and playing back from a wide array of sources. We know most people use their headphones with a smartphone, often with lower-quality MP3 resolution tracks, so we do, too.
I will get to these today. Just imagine the sound you hear is a line stretching left to right, with bass at the left and treble to the right. Now the line is tilted toward the right so the bass is higher (stronger) and the treble lower (weaker). That’s an example of getting darker. It’s not a perfect analogy, since any complex combination of sounds or balance is possible, but in general when something sounds darker you’ll have less influence of the treble.

The thermoacoustic effect generates sound from the audio frequency Joule heating of the conductor, an effect that is not magnetic and does not vibrate the speaker. In 2013 a carbon nanotube thin-yarn earphone based on the thermoacoustic mechanism was demonstrated by a research group in Tsinghua University.[22] The as-produced CNT thin yarn earphone has a working element called CNT thin yarn thermoacoustic chip. Such a chip is composed of a layer of CNT thin yarn array supported by the silicon wafer, and periodic grooves with certain depth are made on the wafer by micro-fabrication methods to suppress the heat leakage from the CNT yarn to the substrate.[citation needed]

I’ve had only a few minutes one day with a 598, so I can’t say exactly. But since the HP100 is closed and the 598 is open, I would get the 598, as long as open back is OK for you. I don’t think you can go wrong with the 598 in any case – it’s a very good headphone. Watch carefully for any cracks to develop though, since there were many reports of that.
Dale: There are so many types of amplifiers (and DAC’s with amplifiers) that there is no shortcut for studying all of the options, unless you settle for the most generic approach. Important things to consider are power – if you don’t have enough power for your headphone and the dynamics in the music, clipping will result. Sometimes the clipping is “soft” and not readily noticed, but eventually you would discover that much of the detail goes missing or gets veiled with limited dynamics. Another consideration is whether to use a DAC, which may be a separate DAC or built into the same enclosure as the amp. Most DACs will improve the sound over the DACs that are built into computers, but when a DAC is available to replace the DAC built into most cellphones and low to mid-priced music players, you can usually expect a much greater improvement.
Despite big promises from Bluetooth’s only Hi-res codec, the standard doesn’t really deliver at best, and it falls far short with its basic 330kbps setting. Both the 660kbps and 990kbps connections offer decent quality, but the 330kbps setting has a lot of noise—and a comparatively poor frequency response with higher-def content. You probably won’t hear it, but it definitely falls short of the marketing.
Every single Bluetooth codec has significant quality issues—despite many creative solutions employed to make the most of the limited bandwidth the standards employ. For those keeping score at home: not a single codec available can meet wired signal quality. Though Bluetooth audio has come a long way since its noisy beginnings, it’s still not ready to replace the headphone jack. Qualcomm’s aptx HD, and Sony’s LDAC 990kbps codecs come close, but everything else falls far short of the mark.

A. Near-field communication, better known as NFC, is a wireless connectivity protocol similar to Bluetooth. NFC uses less power than Bluetooth and is faster when pairing devices, but it only has a range of about four inches. Some headphones use NFC technology to drive the process of pairing headphones with smartphones, but because of the range, it’s not used to transmit sound. While both Android phones and iPhones include NFC chips, it’s not accessible in Apple devices, so if you want a pair of headphones with NFC, you’ll need to own an Android phone to take advantage of the faster pairing.

Ok, it’s been a month and a lot of new experience. I’ve auditoned ATH M-50 (clamp’s too tight; they sweat my ears just from few minutes of exposure) and Senn HD 600 (the velour pad is amazingly comfortable & size is ok). So, long story short, now I can refine my search to: circumaural&non-pleather/foam pads, which brought me to Senn HD 439 (cloth) & 518 (velour).
Fathers Day is just around the corner and we want to help you find the right gift for the amazing fathers in your life. At RadioShack of Lenoir, we have some awesome deals going on RIGHT NOW! Buy the Nebo Big Daddy Flashlight (2000 lumens) and get the Nebo Blast half off, Nebo Knives are buy one get one half off, and Nebo flipits are buy one get one 40% off. We also have some awesome Bluetooth portable speakers that can be taken to the lake, bonfire, or the beach. Also, come by and enter your father to win a Nebo glow light along with a Nebo cup! We hope to see you soon!
×