AAC has some advantages when it comes to latency, but we recommend avoiding this if you care about audio quality. We found high levels of noise and lower than average frequency cutoffs—both unacceptable to audiophiles and younger listeners. Though the sound isn’t as bad as some may make it out to be, the shortcomings are noticeable to the human ear at normal listening volumes.
The iPhone will drive the headphone fine and make a very nice sound, but the amp will make a big improvement in harmonic extension and soundstage. Use the amp whenever possible. Both Headfonia and I concur that the E07k is a great amp, and probably the best thing you can get for up to twice the price. I’m familiar only with the E07k, the E17, and the E12. I think the E07k beats the E17 (and both are also USB DACs), while the E12 is just an amp, and has a darker sound but with more power for inefficient headphones. The Philips is not inefficient.
The usual way of limiting sound volume on devices driving headphones is by limiting output power. This has the additional undesirable effect of being dependent of the efficiency of the headphones; a device producing the maximum allowed power may not produce adequate volume when paired with low-efficiency, high-impedance equipment, while the same amount of power can reach dangerous levels with very efficient earphones.
Historically, many headphones had relatively high impedance, often over 500 ohms so they could operate well with high-impedance tube amplifiers. In contrast, modern transistor amplifiers can have very low output impedance, enabling lower-impedance headphones. Unfortunately, this means that older audio amplifiers or stereos often produce poor-quality output on some modern, low-impedance headphones. In this case, an external headphone amplifier may be beneficial.
Dale: The examples listed above are good general rules, but there also are so many exceptions and in-betweens that it also could be better to understand what is needed for your music, so you can narrow the search to the most appropriate headphones. For example, you may have heard that Classical music is a particular genre, but within that ‘genre’ are many very different types of music. Chamber music or pipe organ music may benefit from a headphone that’s highly detailed in the treble (a headphone that some users might say is bright), while harpsichord music and music that has a lot of strong trumpet sounds might be better served with a more rounded or softer treble.
Alternatively, online calculators can be used.[13] Once the sensitivity per volt is known, the maximum volume for a pair of headphones can be easily calculated from the maximum amplifier output voltage. For example, for a headphone with a sensitivity of 100 dB (SPL)/V, an amplifier with an output of 1 root mean square (RMS) voltage produces a maximum volume of 100 dB.

A. It can be difficult, so buy earbuds that include silicone tips in multiple sizes. Everyone’s ears are unique, so most earbud manufactures include small, medium, and large silicone tips that you can easily swap out. If you want a particularly snug fit, consider getting third-party earphone tips made of memory foam, which will always adjust to the contours of your ears.
I think it’s fair to compare the Grados and HD598, but the M50 is very different and seems not to fit in that comparison. The DT770 is a better comparison to the M50, although the 770 is a better more expensive item. A long time ago I had a Grado 325 and a Sennheiser HD565 – very similar, very enjoyable. Today for that type of sound I might choose the Soundmagic HP100.
A planar magnetic driver consists of a relatively large membrane that contains an embedded wire pattern. This membrane is suspended between two sets of permanent, oppositely aligned, magnets. A current passed through the wires embedded in the membrane produces a magnetic field that reacts with the field of the permanent magnets to induce movement in the membrane, which produces sound.
Noise cancellation: Noise-cancelling headphones play specific tones, much like white noise, to cancel out all of the sound around you and allow you to enjoy your music uninterrupted. Noise-cancellation is an active process, so headphones with this feature require batteries. If you’re a frequent flyer, or if you’ve got a noisy commute to work each day, you’ll love noise-cancelling headphones: they’re fantastic at keeping the cacophony of the outside world at bay.

Communication headsets are used for two-way communication and typically consist of a headphone and attached microphone. Such headsets are used in a variety of professions as aviation, military, sports, music, and many service-oriented sectors. They come in all shapes and sizes, depending on use, required noise attenuation, and fidelity of communication needed.

A. It depends. Noise-cancelling headphones use active technology to play unique frequencies that block outside noises, and depending on which model you buy, the battery can last anywhere from 15 to 40 hours. If you’re using a set of wireless headphones, the battery will be used for both noise cancellation and wireless connectivity, so expect the battery to deplete faster if you’re using both.
Sony’s technologically advanced WH-1000xM3 are the third generation of Sony’s flagship wireless headphones (following the excellent WH-1000xM2 and MDR-1000x models) that offer top-tier noise canceling, excellent quality wireless audio, and plush comfort. This enticing combination earned the model a rare five-star rating in our initial review, and — thanks to a few notable improvements — makes the latest version the best headphones you can buy.
Magnetostriction headphones, sometimes sold under the label Bonephones, work by vibrating against the side of head, transmitting sound via bone conduction. This is particularly helpful in situations where the ears must be unobstructed, or for people who are deaf for reasons that don't affect the nervous apparatus of hearing. Magnetostriction headphones though, are limited in their fidelity compared to conventional headphones that rely on the normal workings of the ear. Additionally, in the early 1990s, a French company called Plasmasonics tried to market a plasma-ionisation headphone. There are no known functioning examples left.
We still wish you could control volume using the same touch gestures that control playback, but then again, you can always ask Alexa to adjust the volume instead. Battery life at 5 hours per charge is about average these days, as is the 20 hours of total playtime enabled by the charging case. Both are minor drawbacks to what is by far the best value in the true wireless market today.
The DT770 is fine – not basshead, the COP is the same size and configuration as the 770, and both of those, large though they are, are “tighter” built so they feel less clunky than the M50. But the biggest problem for you is that the smaller headphones under $200 almost all have a steeply rolled-off treble, which is trouble for the more refined type of music. One possible exception is the Harman Soho.
Dale: The examples listed above are good general rules, but there also are so many exceptions and in-betweens that it also could be better to understand what is needed for your music, so you can narrow the search to the most appropriate headphones. For example, you may have heard that Classical music is a particular genre, but within that ‘genre’ are many very different types of music. Chamber music or pipe organ music may benefit from a headphone that’s highly detailed in the treble (a headphone that some users might say is bright), while harpsichord music and music that has a lot of strong trumpet sounds might be better served with a more rounded or softer treble.
I tend to regard the M50 as the minimum for hi-fi listening with no apologies for limitations. But if you have to go cheaper than the usual $125 USD for the M50, the B&O Form2 with a simple bass boost gives a real hi-fi sound, and it should be available for about $100. The Beyer DTX-501P (similar to soundmagic P30) is good for $100, but needs a slight treble boost. The LSTN Fillmore with wood cups is somewhat colored, but still a good listen and good for $100. Below $100 are the Sennheiser PX series – not hi-fi by any means. There are several good IEMs below $100, and Apple Earpods with a Dirac or Accudio Pro player are very hi-fi, and cheap.
Audiophiles generally agree that if you’re passionate about music, and you have a listening space that is relatively free of outside sounds, nothing beats a really good set of open-back headphones. As far as we’re concerned, you won’t find a set of open-back headphones that manage to combine superb sound quality and a reasonable price than the Sennheiser HD6XX/HD650. To be clear, these are not exactly the same models. The HD6XX is a run of the HD650 with a lower price from Massdrop, and a few physical changes, but when it comes to their audio chops, they’re identical.

Wired headphones are attached to an audio source by a cable. The most common connectors are 6.35 mm (¼″) and 3.5 mm phone connectors. The larger 6.35 mm connector is more common on fixed location home or professional equipment. The 3.5 mm connector remains the most widely used connector for portable application today. Adapters are available for converting between 6.35 mm and 3.5 mm devices.
×