Marketed claims such as 'frequency response 4 Hz to 20 kHz' are usually overstatements; the product's response at frequencies lower than 20 Hz is typically very small. Headphones are also useful for video games that use 3D positional audio processing algorithms, as they allow players to better judge the position of an off-screen sound source (such as the footsteps of an opponent or their gunfire).
Dirac is mainly for resonance (narrow band) taming and not suitable for normal EQ. Accudio is good. But since the L1 already has a strong bass emphasis, boosting mids or treble just makes the imbalance worse – i.e. the freq. response becomes more ragged and the sound more harsh. To get a smoother sound and better mids and treble, reduce the bass instead.
Restock! Check out this 60 Watt Digital Soldering Station! This 60W digital soldering station takes the guesswork out of the temperature equation. -Temperature dial allows for precise settings ranging from 302ºF to 842ºF (150ºC to 450ºC). -Digital LCD display shows actual temperature and setting. -Temperature display toggles between Fahrenheit and Celsius. -3 temperature presets for common settings: 392ºF (200ºC), 680ºF (360ºC) and 788ºF (420ºC). -Detachable iron with pencil-style tip. -Includes cradle stand. -Works with lead-free, rosin-core, lead-based or silver-bearing solder. -Be prepared for any job, and stock up on a variety of solder, including rosin-core, lead-free, silver-bearing, clear flux and more.
Dale: There are so many types of amplifiers (and DAC’s with amplifiers) that there is no shortcut for studying all of the options, unless you settle for the most generic approach. Important things to consider are power – if you don’t have enough power for your headphone and the dynamics in the music, clipping will result. Sometimes the clipping is “soft” and not readily noticed, but eventually you would discover that much of the detail goes missing or gets veiled with limited dynamics. Another consideration is whether to use a DAC, which may be a separate DAC or built into the same enclosure as the amp. Most DACs will improve the sound over the DACs that are built into computers, but when a DAC is available to replace the DAC built into most cellphones and low to mid-priced music players, you can usually expect a much greater improvement.
If you just want to block out sound without active noise cancellation, good over-ear headphones will naturally do that to some extent. This is called noise isolation, and it simply works from the earcups forming a good seal over your ears to prevent outside noise from getting in. It's not as effective, but it's less expensive than active noise cancellation and doesn't require power.
If you have a bass problem you could find a filter of some kind that cuts the low bass. Some bass controls can do that. I haven’t found a music genre that totally lacks strong bass, although “acoustic” sometimes doesn’t have strong bass. Mainly, you should make sure your system is matched properly with amp and headphone, so the different frequencies are in balance. Then you will have better luck with different music.
In-ear headphones are like earbuds but are an upgrade to them. These headphones fit into the wearer's ear canal and stay in place with the use of foam or rubber tips. These tips are available in custom sizes so they can fit each individual wearer. When a proper fit's achieved, in-ear headphones reduce outside noise and deliver sound quality at about the same level as over-ear and on-ear headphones.