Pairing high sensitivity headphones with power amplifiers can produce dangerously high volumes and damage headphones. The maximum sound pressure level is a matter of preference, with some sources recommending no higher than 110 to 120 dB. In contrast, the American Occupational Safety and Health Administration recommends an average SPL of no more than 85 dB(A) to avoid long-term hearing loss, while the European Union standard EN 50332-1:2013 recommends that volumes above 85 dB(A) include a warning, with an absolute maximum volume (defined using 40–4000 Hz noise) of no more than 100 dB to avoid accidental hearing damage. Using this standard, headphones with sensitivities of 90, 100 and 110 dB (SPL)/V should be driven by an amplifier capable of no more than 3.162, 1.0 and 0.3162 RMS volts at maximum volume setting, respectively to reduce the risk of hearing damage.
This type combines advantages of earbuds and in-ear headphones – depending on the environment and requirements of the user, they provide passive noise reduction for quality mode (conversation or active music listening) or they give control over the sound environment around user in comfort mode (stand by or background voice/music listening).
Despite big promises from Bluetooth’s only Hi-res codec, the standard doesn’t really deliver at best, and it falls far short with its basic 330kbps setting. Both the 660kbps and 990kbps connections offer decent quality, but the 330kbps setting has a lot of noise—and a comparatively poor frequency response with higher-def content. You probably won’t hear it, but it definitely falls short of the marketing.
The Elite Active 65t come with three sets of silicone tips and feature an ergonomic design that guarantees a good seal, which is a big reason we prefer them to other true wireless models. With outstanding comfort and excellent passive noise isolation, you get the most out of every note, and you can also lower the volume for less ear strain. Overall sound quality is solid, and sound comes through clear and balanced, with a punchy bass response and a surprisingly dynamic treble range.
The outer shells of in-ear headphones are made up of a variety of materials, such as plastic, aluminum, ceramic and other metal alloys. Because in-ear headphones engage the ear canal, they can be prone to sliding out, and they block out much environmental noise. Lack of sound from the environment can be a problem when sound is a necessary cue for safety or other reasons, as when walking, driving, or riding near or in vehicular traffic.
Sensitivity is a measure of how effectively an earpiece converts an incoming electrical signal into an audible sound. It thus indicates how loud the headphones are for a given electrical drive level. It can be measured in decibels of sound pressure level per milliwatt (dB (SPL)/mW) or decibels of sound pressure level per volt (dB (SPL) / V). Unfortunately, both definitions are widely used, often interchangeably. As the output voltage (but not power) of a headphone amplifier is essentially constant for most common headphones, dB/mW is often more useful if converted into dB/V using Ohm's law:
Dale: The examples listed above are good general rules, but there also are so many exceptions and in-betweens that it also could be better to understand what is needed for your music, so you can narrow the search to the most appropriate headphones. For example, you may have heard that Classical music is a particular genre, but within that ‘genre’ are many very different types of music. Chamber music or pipe organ music may benefit from a headphone that’s highly detailed in the treble (a headphone that some users might say is bright), while harpsichord music and music that has a lot of strong trumpet sounds might be better served with a more rounded or softer treble.
We are excited to announce that we are moving! To better serve our customers we will be moving from our current location on Morganton Blvd to Harper Ave across from McDonald’s in Lenoir (the old Music Center Location). We have closed our location on Morganton Blvd and will reopen at our Harper Ave. location on Wednesday. Due to the move, we may not be able to answer the store phone. For any questions, please message us here on Facebook or email us at [email protected] We can’t wait for you all to see the new RadioShack of Lenoir!