Preferences for the length of headphone cables vary for portable users, especially depending on where you prefer to wear your device: a backpack or a pants pocket necessitates a longer cable, while you'll opt for a short one when wearing a player on a neck lavalier or an armband. But a cable length at either extreme need not be a fatal flaw: extension cables can lengthen those that are too short, and cable wraps can tighten up ones that are too long.

Hearing risk from headphones' use also applies to workers who must wear electronic or communication headsets as part of their daily job (i.e., pilots, call center and dispatch operators, sound engineers, firefighters, etc.) and hearing damage depends on the exposure time. The National Institute for Occupational Safety and Health (NIOSH) recommends sound exposure not exceed 85 dB(A) over 8 hour work day as a time-weighted average.[35] NIOSH uses the 3-dB exchange rate often referred to as "time-intensity tradeoff" which means if sound exposure level is increased by 3 decibels, the duration of exposure should be cut in half. NIOSH published several documents targeted at protecting the hearing of workers who must wear communication headsets such as call center operators,[36] firefighters,[37] and musicians and sound engineers.[38]
Restock! Check out this 60 Watt Digital Soldering Station! This 60W digital soldering station takes the guesswork out of the temperature equation. -Temperature dial allows for precise settings ranging from 302ºF to 842ºF (150ºC to 450ºC). -Digital LCD display shows actual temperature and setting. -Temperature display toggles between Fahrenheit and Celsius. -3 temperature presets for common settings: 392ºF (200ºC), 680ºF (360ºC) and 788ºF (420ºC). -Detachable iron with pencil-style tip. -Includes cradle stand. -Works with lead-free, rosin-core, lead-based or silver-bearing solder. -Be prepared for any job, and stock up on a variety of solder, including rosin-core, lead-free, silver-bearing, clear flux and more.
Released in 2017, the Bose SoundWear Companion is a different kind of wireless headset. It doesn’t have any earcups or earbuds, but instead it sits around your neck adn has speakers that shoot sound up towards your ear — it’s essentially a portable speaker that sits around your neck. It’s water-resistant, so you can technically work out while wearing it, but it’s really designed for the person who works at home. It’s comfortable enough to wear for lengthy periods of time, but it also has excellent built-in microphones and works great as a speakerphone.
The Bose QuietComfort 25 were released in 2015 and you can still buy them today. They are kind of like a wired version of the Bose QuietComfort 35. They have a slightly dated look, and boast almost as good levels of active noise-cancellation and sound quality as Bose’s QuietComfort 35. The important thing to remember is that even though these are wired headphones, they still need to be charged so you can turn on the active noise cancellation. Otherwise, they just work as normal over-ear headphones.

Marketed claims such as 'frequency response 4 Hz to 20 kHz' are usually overstatements; the product's response at frequencies lower than 20 Hz is typically very small.[23] Headphones are also useful for video games that use 3D positional audio processing algorithms, as they allow players to better judge the position of an off-screen sound source (such as the footsteps of an opponent or their gunfire).

64 audio A&K AAW ALO Audio Astell Astell & Kern Astell 'n Kern AstellKern astellnkern Audez'e Audioquest Audio Technica Beyerdynamic Burson canjam Cayin Chord Chord Electronics CypherLabs Earsonics Effect Audio Empire Ears Fiio Flare Audio giveaway Grado Hifiman Ibasso JH Audio Jomo Jomo Audio Meze Noble Audio Nuforce picture Sunday Picture Wednesday plusSound Review Sennheiser Sony STAX The Fav album of Ultimate Ears Watch it Wednesday Wayback Wednesday
These headphones rest on top of your outer ears and run the gamut from inexpensive portables to high-end home models. While on-ear headphones can have closed designs that cover the ears, some prefer fully sealed circumaural models (see below) for their increased sound isolation and the fact that they won't leak sound to neighbors. Still, the earpad headphone is preferred in places like office environments, where users still benefit from hearing the outside world.
For older models of telephones, the headset microphone impedance is different from that of the original handset, requiring a telephone amplifier for the telephone headset. A telephone amplifier provides basic pin-alignment similar to a telephone headset adaptor, but it also offers sound amplification for the microphone as well as the loudspeakers. Most models of telephone amplifiers offer volume control for loudspeaker as well as microphone, mute function and switching between headset and handset. Telephone amplifiers are powered by batteries or AC adaptors.
Dirac is mainly for resonance (narrow band) taming and not suitable for normal EQ. Accudio is good. But since the L1 already has a strong bass emphasis, boosting mids or treble just makes the imbalance worse – i.e. the freq. response becomes more ragged and the sound more harsh. To get a smoother sound and better mids and treble, reduce the bass instead.
These headphones pack about 16 hours of battery life, which ought to be enough for a whole day or more, but if not, there’s always the option of using an analog cable instead. An external switch lets you turn the noise cancellation on and off. Make no mistake, these might be aimed at kids, but the quality of construction, selection of materials, and color choices give them an appearance that will still appeal to your young charges long after they’ve outgrown their Disney phase (some of us still haven’t).
Headphones may be used with stationary CD and DVD players, home theater, personal computers, or portable devices (e.g., digital audio player/MP3 player, mobile phone). Cordless headphones are not connected to their source by a cable. Instead, they receive a radio or infrared signal encoded using a radio or infrared transmission link, such as FM, Bluetooth or Wi-Fi. These are powered receiver systems, of which the headphone is only a component. Cordless headphones are used with events such as a Silent disco or Silent Gig.
The design is not mechanically stable; a slight imbalance makes the armature stick to one pole of the magnet. A fairly stiff restoring force is required to hold the armature in the 'balance' position. Although this reduces its efficiency, this design can still produce more sound from less power than any other[clarification needed]. Popularized in the 1920s as Baldwin Mica Diaphragm radio headphones, balanced armature transducers were refined during World War II for use in military sound powered telephones. Some of these achieved astonishing electro-acoustic conversion efficiencies, in the range of 20% to 40%, for narrow bandwidth voice signals.

Hey Mike, I’m a mixing Engineer looking to invest in a high end pair of headphones for when i’m forced to mix a song on the road. I already have the DT 770 pros and BEATS by dre headphones which i feel will be good enough for references. But I’m looking for a 3rd pair that really has a flat response and that is very detailed. I’m willing to spend $1,500 to $2,500. Are there any headphones you can recommend looking into. Thanks

Generally, headphones are able to reproduce richer low-end audio, since they have larger drivers than earphones and they don't rely on an in-ear seal to deliver sound. Some listeners also find headphones more comfortable to wear, and easier to put on and take off, than they do earphones. This naturally means that headphones are bulkier, and less suited to the gym.
We run every pair through a rigorous testing process over several days or weeks. That includes playing them in all sorts of scenarios — be it on a bus, in the listening room, or at the office — and playing back from a wide array of sources. We know most people use their headphones with a smartphone, often with lower-quality MP3 resolution tracks, so we do, too.
Sports headphones are among the most popular types of headphones and the best ones are now wireless. Sweat-resistant or even totally waterproof, they can be used at the gym or for running or biking. Some are have an open or semi-open design to let some sound in for safety reasons (so you can hear traffic noise). However, other models have a sealed, noise-isolating design.
Circumaural headphones (sometimes called full size headphones or over-ear headphones) have circular or ellipsoid earpads that encompass the ears. Because these headphones completely surround the ear, circumaural headphones can be designed to fully seal against the head to attenuate external noise. Because of their size, circumaural headphones can be heavy and there are some sets that weigh over 500 grams (1 lb). Ergonomic headband and earpad design is required to reduce discomfort resulting from weight. These are commonly used by drummers in recording.
What I’m saying here is that it’s better to own three $100 headphones than one $300 headphone. Or three $300 headphones than one $900 headphone. Why? Because most people don’t limit their playlist to strictly one genre. And following the logic from Rule #2, the right headphone-music pairing is going to be better than one expensive headphone paired to the wrong music.

I’ve never enjoyed the audio quality of Bluetooth headphones, but that’s just me. The sound is better than it ever has been, and it’ll get you 90% of the way there—but not everybody is willing to make that tradeoff. Since USB-C headphones have largely ceded their market advantages over Bluetooth, we have to examine the consumer audio technology’s performance in a world where the headphone jack is disappearing.
While noise-canceling headphones are what it’s best known for, Bose makes plenty of other high-quality headphones and earbuds for people who don’t want or need noise cancellation, which degrades audio quality and costs a premium. From true wireless AirPod competitors to old-school wired earbuds, to just cheaper wireless over-ear cans, Bose makes a headphone for every style and, more importantly, for every budget.
Ok, it’s been a month and a lot of new experience. I’ve auditoned ATH M-50 (clamp’s too tight; they sweat my ears just from few minutes of exposure) and Senn HD 600 (the velour pad is amazingly comfortable & size is ok). So, long story short, now I can refine my search to: circumaural&non-pleather/foam pads, which brought me to Senn HD 439 (cloth) & 518 (velour).

Dale: There are so many types of amplifiers (and DAC’s with amplifiers) that there is no shortcut for studying all of the options, unless you settle for the most generic approach. Important things to consider are power – if you don’t have enough power for your headphone and the dynamics in the music, clipping will result. Sometimes the clipping is “soft” and not readily noticed, but eventually you would discover that much of the detail goes missing or gets veiled with limited dynamics. Another consideration is whether to use a DAC, which may be a separate DAC or built into the same enclosure as the amp. Most DACs will improve the sound over the DACs that are built into computers, but when a DAC is available to replace the DAC built into most cellphones and low to mid-priced music players, you can usually expect a much greater improvement.
In early powered radios, the headphone was part of the vacuum tube's plate circuit and carried dangerous voltages. It was normally connected directly to the positive high voltage battery terminal, and the other battery terminal was securely grounded. The use of bare electrical connections meant that users could be shocked if they touched the bare headphone connections while adjusting an uncomfortable headset.
×