Hi. I have more or less decided that the Philips Fidelio L1s are the ones for me. I plan to use them on my commute paired with an iPhone or the iPad as the source. I listen to a mix of pop, rock, blues and jazz so I’m not after boosting bass but I might want to fiddle with the dial on the treble and mids. Which brings me to my question. You state in your review that the L2s pair well with the Fiio e17 which lets you independently adjust treble and bass. Could the same effect be achieved lower down the $$ curve via a combination of say a Fiio E6 (for signal amplification) and a Dirac or Accudio app for equalisation?
With a Lightning a USB-C headphone you plug the headphone directly into the Lightning port (on Apple devices) or USB-C port (on Android devices). A standard headphone plug is an analog connection while this creates a direct digital connection. The headphones are powered by your phone (they use only a little bit of battery power) and have an integrated DAC (digital-to-analog converter) that's usually superior to the DAC in your phone.
Released in 2017, the Bose QuietComfort 35 (Series I) are essentially the exact same headphones as the Series II. They have the same design, feel, sound quality and noise-canceling skills. The difference is that the Series I don’t have Google Assistant built-in and a dedicated button on the left ear cup to activate it. If you don’t care about talking to a virtual assistant while wearing your headphones, which allows you to play/pause music or skip tracks via a verbal command, then Series I or Series II shouldn’t matter to you. The catch is that the Series I is more difficult to find online and they aren’t usually that much cheaper than the Series II.
Sensitivity is a measure of how effectively an earpiece converts an incoming electrical signal into an audible sound. It thus indicates how loud the headphones are for a given electrical drive level. It can be measured in decibels of sound pressure level per milliwatt (dB (SPL)/mW) or decibels of sound pressure level per volt (dB (SPL) / V). Unfortunately, both definitions are widely used, often interchangeably. As the output voltage (but not power) of a headphone amplifier is essentially constant for most common headphones, dB/mW is often more useful if converted into dB/V using Ohm's law:
That amp, if in good working condition, has 100 times the potential sound quality that those 2 headphones can play. You could improve the sound somewhat with a careful EQ, since the Marantz will have power reserve to spare. But I’d try to find a better headphone, and there are some bargains out there. If I were suggesting an ortho, I’d say get the lower price Mad Dog, which will give you great audiophile sound with the Marantz.
In-ear headphones are like earbuds but are an upgrade to them. These headphones fit into the wearer's ear canal and stay in place with the use of foam or rubber tips. These tips are available in custom sizes so they can fit each individual wearer. When a proper fit's achieved, in-ear headphones reduce outside noise and deliver sound quality at about the same level as over-ear and on-ear headphones.