I will post some comments. If I forget let me know here. My main reason for ordering was the old pads on the 1350 wouldn’t make a good bass seal in colder weather, and Beyer has upgraded the pads on both the 1350 and the T51p, so I’m hoping for a better seal this time. I don’t know of any headphone that size that ‘s as accurate and detailed as those little Tesla models, and the carrycase is icing on the cake.
The moving coil driver, more commonly referred to as a "dynamic" driver is the most common type used in headphones. It consists of a stationary magnet element affixed to the frame of the headphone, which sets up a static magnetic field. The magnet in headphones is typically composed of ferrite or neodymium. A voice coil, a light coil of wire, is suspended in the magnetic field of the magnet, attached to a diaphragm, typically fabricated from lightweight, high-stiffness-to-mass-ratio cellulose, polymer, carbon material, paper or the like. When the varying current of an audio signal is passed through the coil, it creates a varying magnetic field that reacts against the static magnetic field, exerting a varying force on the coil causing it and the attached diaphragm to vibrate. The vibrating diaphragm pushes on the air to produce sound waves.
Released in 2015, the SoundLink Around-Ear II are Bose’s wireless over-ear headphones that don’t have active noise cancellation. They’re lighter and slightly more travel-friendly than a lot of the company’s other offerings, and they could sound quality at the forefront. At the time, the big selling point for the SoundLink Around-Ear II was their sound quality — Bose claimed that they sounded as good as wired headphones, which admittedly doesn’t hold up in 2019 (streaming and Bluetooth have gotten too good).

Dale: There are so many types of amplifiers (and DAC’s with amplifiers) that there is no shortcut for studying all of the options, unless you settle for the most generic approach. Important things to consider are power – if you don’t have enough power for your headphone and the dynamics in the music, clipping will result. Sometimes the clipping is “soft” and not readily noticed, but eventually you would discover that much of the detail goes missing or gets veiled with limited dynamics. Another consideration is whether to use a DAC, which may be a separate DAC or built into the same enclosure as the amp. Most DACs will improve the sound over the DACs that are built into computers, but when a DAC is available to replace the DAC built into most cellphones and low to mid-priced music players, you can usually expect a much greater improvement.
Although some headphones available are wired, many more are available that are wireless, and use Bluetooth to enable your music to be heard, even if the stereo or other device is several feet or even a few rooms away. Wired headphones deliver superior sound quality to wireless and Bluetooth because there's no chance of picking up interference from other devices, which sometimes happens with wireless headphones. In addition, wired headphones have no batteries to power them, so there's no chance of interruption should the batteries wear out.
×