Headphones can prevent other people from hearing the sound, either for privacy or to prevent disturbing others, as in listening in a public library. They can also provide a level of sound fidelity greater than loudspeakers of similar cost. Part of their ability to do so comes from the lack of any need to perform room correction treatments with headphones. High-quality headphones can have an extremely flat low-frequency response down to 20 Hz within 3 dB. While a loudspeaker must use a relatively large (often 15" or 18") speaker driver to reproduce low frequencies, headphones can accurately reproduce bass and sub-bass frequencies with speaker drivers only 40-50 millimeters wide (or much smaller, as is the case with in-ear monitor headphones). Headphones' impressive low-frequency performance is possible because they are so much closer to the ear that they only need to move relatively small volumes of air.
Dale: The examples listed above are good general rules, but there also are so many exceptions and in-betweens that it also could be better to understand what is needed for your music, so you can narrow the search to the most appropriate headphones. For example, you may have heard that Classical music is a particular genre, but within that ‘genre’ are many very different types of music. Chamber music or pipe organ music may benefit from a headphone that’s highly detailed in the treble (a headphone that some users might say is bright), while harpsichord music and music that has a lot of strong trumpet sounds might be better served with a more rounded or softer treble.
Cable dressing and length: Most stereo headphones have just one cable, usually attached to the left earpiece (sometimes called single-sided cabling). Some models -- and all earbuds -- use a Y-cable that connects to both earpieces (double-sided). The actual cable plug, meanwhile, is usually one of two designs: a straight I-plug or an angled L-plug; the latter may be useful if your portable player has a side- or bottom-mounted headphone jack.
Semi-open headphones, have a design that can be considered as a compromise between open-back headphones and closed-back headphones. Some[who?] believe the term "semi-open" is purely there for marketing purposes. There is no exact definition for the term semi-open headphone. Where the open-back approach has hardly any measure to block sound at the outer side of the diaphragm and the closed-back approach really has a closed chamber at the outer side of the diaphragm, a semi-open headphone can have a chamber to partially block sound while letting some sound through via openings or vents.
Inexpensive: Most casual users can find a good pair of headphones for between $20 and $50. Headphones in this price range sound great, include key features like an in-line microphone, and often support wireless Bluetooth connections. If you’re looking for a reliable set of headphones and you don’t need much more than audio, you don’t need to spend more than $50.
A. Near-field communication, better known as NFC, is a wireless connectivity protocol similar to Bluetooth. NFC uses less power than Bluetooth and is faster when pairing devices, but it only has a range of about four inches. Some headphones use NFC technology to drive the process of pairing headphones with smartphones, but because of the range, it’s not used to transmit sound. While both Android phones and iPhones include NFC chips, it’s not accessible in Apple devices, so if you want a pair of headphones with NFC, you’ll need to own an Android phone to take advantage of the faster pairing.
The thermoacoustic effect generates sound from the audio frequency Joule heating of the conductor, an effect that is not magnetic and does not vibrate the speaker. In 2013 a carbon nanotube thin-yarn earphone based on the thermoacoustic mechanism was demonstrated by a research group in Tsinghua University. The as-produced CNT thin yarn earphone has a working element called CNT thin yarn thermoacoustic chip. Such a chip is composed of a layer of CNT thin yarn array supported by the silicon wafer, and periodic grooves with certain depth are made on the wafer by micro-fabrication methods to suppress the heat leakage from the CNT yarn to the substrate.
As the name gives away, these have an on-ear design instead of the over-ear design of most of Bose’s other offerings. The trade-off is that the On-Ear Wireless Headphones won’t be able to block out ambient noises as well, but some people might find them more comfortable. Plus they’re well cheaper than most other Bose wireless headphones. It should be noted that many reviewers, including Sound Guys, have praised the sound quality of these headphones.
Hearing risk from headphones' use also applies to workers who must wear electronic or communication headsets as part of their daily job (i.e., pilots, call center and dispatch operators, sound engineers, firefighters, etc.) and hearing damage depends on the exposure time. The National Institute for Occupational Safety and Health (NIOSH) recommends sound exposure not exceed 85 dB(A) over 8 hour work day as a time-weighted average. NIOSH uses the 3-dB exchange rate often referred to as "time-intensity tradeoff" which means if sound exposure level is increased by 3 decibels, the duration of exposure should be cut in half. NIOSH published several documents targeted at protecting the hearing of workers who must wear communication headsets such as call center operators, firefighters, and musicians and sound engineers.
Case in point: the Koss PortaPro headphones first hit the market in 1984 and have become such a favorite with audiophiles that the company leaves the design (and the price tag) untouched. You can still pick one up for less than $50, and they come with a lifetime warranty, no receipt necessary. Check out our favorite budget headphones for more selections.
In terms of juice, the Elite 65t offer 5 hours of battery life — matching the AirPods — and the included charging case adds two refills on the go. Jabra also matches many of the best features we’ve seen elsewhere in the fully wireless space, with the company’s Sound+ app that lets you adjust settings like equalization, or whether you want to use your phone’s built-in smart assistant (Siri on iOS, Google Assistant on Android) or Amazon Alexa. Sensors built into the headphones can be set to play and pause music when you remove the buds, and they can even be set to pipe in different levels of ambient sound, which is great for hearing announcements on the plane or your office mate.
Anyway, I’m looking for comfortable headphones for casual listening from my mobile phone, and so far I’m uncomfortable with portables. I have tried many portables in multiple stores, they sweat my ears after few minutes, and their small size never cover my ears properly. Recently I have experienced one of Clarion headphone (dunno which series, its price around Rp 99.000), while its big ear cushion cover my ears properly, I felt too much pressure on the area below my ears, probably due to its weight..
These headphones hush ambient noise by creating anti-noise that obviates the noise at your ear. They don't eliminate the outside world, but the better models significantly reduce the whoosh of airplanes' air-conditioning systems. Noise-canceling headphones come in all forms, from full-size to earbuds. Since you no longer have to crank up the volume to overcome background noise, this type of headphone lets you listen at lower levels, which leads to reduced ear fatigue. You'll also hear more low-level detail in your music.
Dale: There are so many types of amplifiers (and DAC’s with amplifiers) that there is no shortcut for studying all of the options, unless you settle for the most generic approach. Important things to consider are power – if you don’t have enough power for your headphone and the dynamics in the music, clipping will result. Sometimes the clipping is “soft” and not readily noticed, but eventually you would discover that much of the detail goes missing or gets veiled with limited dynamics. Another consideration is whether to use a DAC, which may be a separate DAC or built into the same enclosure as the amp. Most DACs will improve the sound over the DACs that are built into computers, but when a DAC is available to replace the DAC built into most cellphones and low to mid-priced music players, you can usually expect a much greater improvement.
Smaller earbud type earpieces, which plugged into the user's ear canal, were first developed for hearing aids. They became widely used with transistor radios, which commercially appeared in 1954 with the introduction of the Regency TR-1. The most popular audio device in history, the transistor radio changed listening habits, allowing people to listen to radio anywhere. The earbud uses either a moving iron driver or a piezoelectric crystal to produce sound. The 3.5 mm radio and phone connector, which is the most commonly used in portable application today, has been used at least since the Sony EFM-117J transistor radio, which was released in 1964. Its popularity was reinforced with its use on the Walkman portable tape player in 1979.