I will get to these today. Just imagine the sound you hear is a line stretching left to right, with bass at the left and treble to the right. Now the line is tilted toward the right so the bass is higher (stronger) and the treble lower (weaker). That’s an example of getting darker. It’s not a perfect analogy, since any complex combination of sounds or balance is possible, but in general when something sounds darker you’ll have less influence of the treble.
Due to the extremely thin and light diaphragm membrane, often only a few micrometers thick, and the complete absence of moving metalwork, the frequency response of electrostatic headphones usually extends well above the audible limit of approximately 20 kHz. The high frequency response means that the low midband distortion level is maintained to the top of the audible frequency band, which is generally not the case with moving coil drivers. Also, the frequency response peakiness regularly seen in the high frequency region with moving coil drivers is absent. Well-designed electrostatic headphones can produce significantly better sound quality than other types.[citation needed]
Communication headsets are used for two-way communication and typically consist of a headphone and attached microphone. Such headsets are used in a variety of professions as aviation, military, sports, music, and many service-oriented sectors. They come in all shapes and sizes, depending on use, required noise attenuation, and fidelity of communication needed.

Their combination of dual balanced-armature drivers matched with a dynamic driver to pump up the lower end are kind of engineering normally found on products that cost more than double the price of the 1Mores. Even the smaller details are very well ironed out, such as Kevlar-wrapped cables that increase resistance to wear while simultaneously reducing tangles.

The Bose Frames are non-polarized sunglasses with special speakers built into each arm. The idea is that they’re designed to look like regular sunglasses, but also act as Bluetooth headphones. Since there’s no earbud that actually goes into your ears, the speakers have been engineered to shoot audio down into your ears; the neat thing is that the Bose Frames do a very good job at masking your audio so that the people around you can’t really hear what you’re listening to. They are available in two different frame styles, round (Rondo) or square (Aldo).
Case in point: the Koss PortaPro headphones first hit the market in 1984 and have become such a favorite with audiophiles that the company leaves the design (and the price tag) untouched. You can still pick one up for less than $50, and they come with a lifetime warranty, no receipt necessary. Check out our favorite budget headphones for more selections.
Communication headsets are used for two-way communication and typically consist of a headphone and attached microphone. Such headsets are used in a variety of professions as aviation, military, sports, music, and many service-oriented sectors. They come in all shapes and sizes, depending on use, required noise attenuation, and fidelity of communication needed.
The Astro Gaming A50 emerged in 2012 as the wireless follow-up to the excellent A40. Seven years later and four generations on, they remain the gold standard for gaming audio. With an ability to faithfully reproduce 7.1 channel surround sound through just two earcups, gamers will get critical 3D audio for all of their favorite console titles whether it’s from an Xbox One or a PlayStation 4. Wireless audio can lead to an unacceptable amount of lag, which often sends gamers in search of wired models, but here too, the A50 manage to beat expectations.
The Bose Frames are non-polarized sunglasses with special speakers built into each arm. The idea is that they’re designed to look like regular sunglasses, but also act as Bluetooth headphones. Since there’s no earbud that actually goes into your ears, the speakers have been engineered to shoot audio down into your ears; the neat thing is that the Bose Frames do a very good job at masking your audio so that the people around you can’t really hear what you’re listening to. They are available in two different frame styles, round (Rondo) or square (Aldo).
I’ve had only a few minutes one day with a 598, so I can’t say exactly. But since the HP100 is closed and the 598 is open, I would get the 598, as long as open back is OK for you. I don’t think you can go wrong with the 598 in any case – it’s a very good headphone. Watch carefully for any cracks to develop though, since there were many reports of that.
Technology has changed our lives in some pretty big ways – nowadays, it’s hard to imagine leaving the house without at least a few of our most important gadgets. New tech categories are sprouting up out of nowhere; ten years ago, no one had ever heard of a smartwatch, and now you see them everywhere you go. But there’s one tech category that’s remained essential all along: headphones.
LDAC is a strange family of codecs, not merely because they’re the only codecs that really attempt the hi-res thing, but because they have perplexing issues with common phones. For example, the bitrate defaults are wildly different from phone to phone. The Samsung Galaxy Note 8 and LG V30 both default to 660kbps, and the Google Pixel 3 defaults to the lesser 330kbps. However, the noise present with every LDAC connection is far greater than it is with a regular old 3.5mm headphone jack.
If you’ll mostly be using headphones at your desk, install a headphone hook so you can safely stow yours when you’re not using them. Headphones can be fairly fragile, so it’s important to take care of yours and avoid tossing them around. A headphone hook gives your favorite pair a place to hang and creates a fun conversation piece for your workstation.

One thing I suggest to prospective customers for a specific headphone, if I have that headphone on hand, is for them to suggest 2 or 3 music tracks by a particular artist and composer that I can sample on that headphone, not so much for me to suggest how it sounds, but mostly to check if that headphone has any real sonic issues with that music. For example, a headphone that’s ideal for classical and acoustic music might sound too harsh with metal and industrial goth.
Supra-aural headphones or on-ear headphones have pads that press against the ears, rather than around them. They were commonly bundled with personal stereos during the 1980s. This type of headphone generally tends to be smaller and lighter than circumaural headphones, resulting in less attenuation of outside noise. Supra-aural headphones can also lead to discomfort due to the pressure on the ear as compared to circumaural headphones that sit around the ear. Comfort may vary due to the earcup material.
The tech-speak description for this type of headphone is "circumaural," which includes any headphones with earcups that fully enclose your ears. Because of their size and their acoustic isolation, full-size headphones are often considered to be better-suited to home use rather than as a portable option, but the recent popularity of full-size, noise-canceling Beats headphones are challenging the rule.
Electrostatic drivers consist of a thin, electrically charged diaphragm, typically a coated PET film membrane, suspended between two perforated metal plates (electrodes). The electrical sound signal is applied to the electrodes creating an electrical field; depending on the polarity of this field, the diaphragm is drawn towards one of the plates. Air is forced through the perforations; combined with a continuously changing electrical signal driving the membrane, a sound wave is generated. Electrostatic headphones are usually more expensive than moving-coil ones, and are comparatively uncommon. In addition, a special amplifier is required to amplify the signal to deflect the membrane, which often requires electrical potentials in the range of 100 to 1000 volts.
The adage that you get what you pay for is generally true for audio products like headphones. What has made us big fans of the 1More brand is its ability to redefine that expectation in surprising ways. The 1More Triple Driver in-ear headphones are a great example of this: They exhibit all of the hallmarks of high-end, expensive earbuds, yet manage to keep the price highly affordable for most people.
If you’ve been on an airplane in the last few years, you’ve probably seen the Bose QuietComfort noise-cancelling headphones before: they’re a favorite of regular travelers because they’re so good at keeping outside noise out. They’re comfortable, they sound incredible, and the noise cancellation is so impressive that you feel like you’re in your own personal bubble. These headphones are not cheap, but they’re definitely worth the money.
Hi. I have more or less decided that the Philips Fidelio L1s are the ones for me. I plan to use them on my commute paired with an iPhone or the iPad as the source. I listen to a mix of pop, rock, blues and jazz so I’m not after boosting bass but I might want to fiddle with the dial on the treble and mids. Which brings me to my question. You state in your review that the L2s pair well with the Fiio e17 which lets you independently adjust treble and bass. Could the same effect be achieved lower down the $$ curve via a combination of say a Fiio E6 (for signal amplification) and a Dirac or Accudio app for equalisation?
Transducer technologies employed much less commonly for headphones include the Heil Air Motion Transformer (AMT); Piezoelectric film; Ribbon planar magnetic; Magnetostriction and Plasma-ionisation. The first Heil AMT headphone was marketed by ESS Laboratories and was essentially an ESS AMT tweeter from one of the company's speakers being driven at full range. Since the turn of the century, only Precide of Switzerland have manufactured an AMT headphone. Piezoelectric film headphones were first developed by Pioneer, their two models used a flat sheet of film that limited the maximum volume of air movement. Currently, TakeT produces a piezoelectric film headphone shaped similarly to an AMT transducer but, which like the Precide driver, has a variation in the size of transducer folds over the diaphragm. It additionally incorporates a two way design by its inclusion of a dedicated tweeter/supertweeter panel. The folded shape of a diaphragm allows a transducer with a larger surface area to fit within smaller space constraints. This increases the total volume of air that can be moved on each excursion of the transducer given that radiating area.
Music keeps me energized all day (and into the night) at work — 70% electronica/dance/DNB, 20% rock, 5% hip hip and 5% other/classical — but I’m tired of low-quality sound and I’m ready to put my money where my ears are.  I want to buy a USB DAC + Headphone amp, buy headphones (or, per your recommendation, to buy 2 pair) to complement the amp and my choice of music, and get great desktop sound for around $350.

hi? i want to ask a question. Im a complete newbie on the audiphilic side so i red on a site that the more the impedance is higher a headphone amp is requierd and less the impedance a headphone amp is not that much requierd cause the headphones with less impedance are made for portable players. Now let me get to the point im using cheap headphones the philips sbc hp250 they are old about 5 years and sound ok but i want to replace them so i use them mostly for listening to hours of music and i am also a musician so would it make a diference if i would buy a behringer headphone amp http://www.amazon.com/Behringer-HA400-4-Channel-Stereo-Headphone/dp/B000KIPT30/ref=sr_1_6?ie=UTF8&qid=1379715994&sr=8-6&keywords=behringer+amplifier and amplify those headphones would they play better cause now im having them plugged on a intergrated via vinyl soundcard http://www.via.com.tw/en/products/audio/codecs/vt1708s/. and they sound shitty on full volume. I am considering to buy new full size headphones and im willing to give max 80 euros for them so for the start i just want them to be loud but i want a clear sound at high volume levels. To be more specific i want a clear sound that is balanced in the lows mids and highs but not distorted and the lows should not be too much overpowered. I was sniffing around your site and found some sennheiser hd 202 ii they are not even close to 80 euros but i heard they sound great would they be better than these philips headphones and what other alternatives would you suggest me for max 80 euros


Although modern headphones have been particularly widely sold and used for listening to stereo recordings since the release of the Walkman, there is subjective debate regarding the nature of their reproduction of stereo sound. Stereo recordings represent the position of horizontal depth cues (stereo separation) via volume and phase differences of the sound in question between the two channels. When the sounds from two speakers mix, they create the phase difference the brain uses to locate direction. Through most headphones, because the right and left channels do not combine in this manner, the illusion of the phantom center can be perceived as lost. Hard panned sounds are also heard only in one ear rather than from one side.
The Galaxy Buds produce exemplary audio quality packed into a pair of unobtrusive earpieces, complete with easy-to-use touch controls for playback, volume, and skipping tracks. According to Samsung, they have a 6-hour battery life and come with a powered carrying case that will recharge the earphones for up to 7 additional hours of playback on the go. The case itself can be charged with a wireless charging mat, and it’s particularly small compared with the cases that come with many true wireless models.
A: Absolutely not... unless you're just looking for an excuse to try something new. But if you're not made of money, you can always hit up the manufacturer for a pair of replacement tips. Most earbuds only come with one set of each size, so losing one can be annoying. If you're in an experimental mood, Comply offers aftermarket tips that fit your brand and come in a variety of materials.
To be honest, I was looking at the M50 because I knew another person that had them & was very happy with them, also I read reviews online which were positive. However, I didn’t realize until now that the possibilities are pretty endless when it comes to headphones, which is why I was asking for some direction… It just sucks cause my budget is definitely limited…
Transducer technologies employed much less commonly for headphones include the Heil Air Motion Transformer (AMT); Piezoelectric film; Ribbon planar magnetic; Magnetostriction and Plasma-ionisation. The first Heil AMT headphone was marketed by ESS Laboratories and was essentially an ESS AMT tweeter from one of the company's speakers being driven at full range. Since the turn of the century, only Precide of Switzerland have manufactured an AMT headphone. Piezoelectric film headphones were first developed by Pioneer, their two models used a flat sheet of film that limited the maximum volume of air movement. Currently, TakeT produces a piezoelectric film headphone shaped similarly to an AMT transducer but, which like the Precide driver, has a variation in the size of transducer folds over the diaphragm. It additionally incorporates a two way design by its inclusion of a dedicated tweeter/supertweeter panel. The folded shape of a diaphragm allows a transducer with a larger surface area to fit within smaller space constraints. This increases the total volume of air that can be moved on each excursion of the transducer given that radiating area.
In-ear headphones are like earbuds but are an upgrade to them. These headphones fit into the wearer's ear canal and stay in place with the use of foam or rubber tips. These tips are available in custom sizes so they can fit each individual wearer. When a proper fit's achieved, in-ear headphones reduce outside noise and deliver sound quality at about the same level as over-ear and on-ear headphones.
×