The SoundSport Wireless are wireless sport earbuds that are very similar to the SoundSport Free. Instead of being true wireless earbuds, however, the two SoundSport Wireless earbuds are tethered together by cable. Aside from that, the two wireless earbuds have similar audio performance and use the same Bose Connect app. The SoundSport Wireless will last longer on a single charge (as opposed to the SoundSport Free which recharge every time they go back in their case).

Restock! Check out this 60 Watt Digital Soldering Station! This 60W digital soldering station takes the guesswork out of the temperature equation. -Temperature dial allows for precise settings ranging from 302ºF to 842ºF (150ºC to 450ºC). -Digital LCD display shows actual temperature and setting. -Temperature display toggles between Fahrenheit and Celsius. -3 temperature presets for common settings: 392ºF (200ºC), 680ºF (360ºC) and 788ºF (420ºC). -Detachable iron with pencil-style tip. -Includes cradle stand. -Works with lead-free, rosin-core, lead-based or silver-bearing solder. -Be prepared for any job, and stock up on a variety of solder, including rosin-core, lead-free, silver-bearing, clear flux and more.


Circumaural headphones (sometimes called full size headphones or over-ear headphones) have circular or ellipsoid earpads that encompass the ears. Because these headphones completely surround the ear, circumaural headphones can be designed to fully seal against the head to attenuate external noise. Because of their size, circumaural headphones can be heavy and there are some sets that weigh over 500 grams (1 lb). Ergonomic headband and earpad design is required to reduce discomfort resulting from weight. These are commonly used by drummers in recording.
Headphones are available with high or low impedance (typically measured at 1 kHz). Low-impedance headphones are in the range 16 to 32 ohms and high-impedance headphones are about 100-600 ohms. As the impedance of a pair of headphones increases, more voltage (at a given current) is required to drive it, and the loudness of the headphones for a given voltage decreases. In recent years, impedance of newer headphones has generally decreased to accommodate lower voltages available on battery powered CMOS-based portable electronics. This has resulted in headphones that can be more efficiently driven by battery-powered electronics. Consequently, newer amplifiers are based on designs with relatively low output impedance.
Digital assistant compatibility: These days, it’s kind of a rite of passage for any tech gear to be compatible with voice-controlled digital assistants, and headphones are no exception. Certain high-end headphones include a microphone that you can use with voice commands to conjure up your favorite digital assistant, but you’ll need to make sure your smartphone is compatible. For example, if you own a Samsung Galaxy S8 phone (or newer version), you can use certain headphones to execute specific voice commands on your phone, such as “Check weather.”
That depends on what you’re using them for and how much you’re willing to spend. At the high-end, over-ear and in-ear headphones can both perform fantastically. For those of us not willing to spend thousands on headphones, over-ear headphones typically offer better bass response and a bigger soundstage, but in-ear headphones are significantly more portable and convenient — especially wireless earbuds.
The Sony noise-cancelling headphones are a tiny miracle. They’re great at blocking the outside world, so you’ll hear your music and nothing else – at a price point that’s less than $50. Wired headphones can be a tough sell for those who’ve grown accustomed to wire-free listening, but if you’re all right with a wired connection, this pair is an easy choice.
What I’m saying here is that it’s better to own three $100 headphones than one $300 headphone. Or three $300 headphones than one $900 headphone. Why? Because most people don’t limit their playlist to strictly one genre. And following the logic from Rule #2, the right headphone-music pairing is going to be better than one expensive headphone paired to the wrong music.
Dirac is mainly for resonance (narrow band) taming and not suitable for normal EQ. Accudio is good. But since the L1 already has a strong bass emphasis, boosting mids or treble just makes the imbalance worse – i.e. the freq. response becomes more ragged and the sound more harsh. To get a smoother sound and better mids and treble, reduce the bass instead.
Preferences for the length of headphone cables vary for portable users, especially depending on where you prefer to wear your device: a backpack or a pants pocket necessitates a longer cable, while you'll opt for a short one when wearing a player on a neck lavalier or an armband. But a cable length at either extreme need not be a fatal flaw: extension cables can lengthen those that are too short, and cable wraps can tighten up ones that are too long.
However, the Bose 700 earphones have a much slimmer profile when folded up, and they have a few updated elements, including more integration with digital assistants, touch controls, and sensors for Bose’s “augmented reality” apps. Bose has kept some of the best-loved features from its older models as well, such as adjustable levels of noise cancellation, a monitoring mode to let in sound from your environment, and an advertised 20-hour battery life. According to Bose, call quality is improved as well, though CR doesn’t test call quality in headphones.
The Earbuds 500 won’t be available until early 2020, but they might just be worth waiting for. They look to be the natural successor to the SoundSport Free, the company’s first go at truly wireless earbuds, but probably better in every way. The Earbuds 500 will likely have a longer battery life, a smaller charging case and charge via USB-C. They will be sport-focused, too, and a more affordable option to the company’s other new-age wireless earbuds, the Noise Cancelling Earbuds 700.
Garbage in = Garbage out (GIGO) is a popular phrase used to emphasize the importance of a good source. This can be the soundcard in your laptop, the quality of your portable audio player, or the CD player you’re using for music listening. Those fall into the “Source” category. The better your source is, the better the sound will be at the headphone end. This is why we are seeing more and more audiophile digital audio players (audiophile DAPs). They are expensive but they sound good.
The outer shells of in-ear headphones are made up of a variety of materials, such as plastic, aluminum, ceramic and other metal alloys. Because in-ear headphones engage the ear canal, they can be prone to sliding out, and they block out much environmental noise. Lack of sound from the environment can be a problem when sound is a necessary cue for safety or other reasons, as when walking, driving, or riding near or in vehicular traffic.[19]
While Apple’s AirPods get a lot of attention for how well they work with other Apple products, there’s actually a more affordable option that’s just as tightly integrated: the Beats BeatsX Earphones. Apple owns the Beats brand, and it’s built the BeatsX earphones with the same W1 chip that’s in the AirPods. That means that the user experience is virtually identical – iOS makes it super easy to pair them with any iPhone or iPad. Our favorite part is they have a Fast Fuel feature, so when your battery is low, plugging them in for five minutes provides two hours of talk time. We’re also big fans of the COWIN E7 Headphones. They’re wireless, they’ve got on-board noise cancellation, and they can last up to 30 hours on a single charge. The E7’s have an impressive spec sheet for any price point, but the fact that they’re so affordable makes them an even better value. If you’re looking for affordable over-the-ear headphones that don’t make any compromises, this is the pair to get.

The impedance of headphones is of concern because of the output limitations of amplifiers. A modern pair of headphones is driven by an amplifier, with lower impedance headphones presenting a larger load. Amplifiers are not ideal; they also have some output impedance that limits the amount of power they can provide. To ensure an even frequency response, adequate damping factor, and undistorted sound, an amplifier should have an output impedance less than 1/8 that of the headphones it is driving (and ideally, as low as possible). If output impedance is large compared to the impedance of the headphones, significantly higher distortion is present.[11] Therefore, lower impedance headphones tend to be louder and more efficient, but also demand a more capable amplifier. Higher impedance headphones are more tolerant of amplifier limitations, but produce less volume for a given output level.
A good headphone should last 25 years. The first thing to replace is earpads usually, since wear affects the sound. Sometimes the cable will get a loose connection and need replaced. The drivers should be good forever, but in some rare cases a hair can work its way in and cause a buzz or rattle. If that happens it’s usually easy to remove an earpad and pull the hair etc. out.
If you want headphones for gaming or watching movies, get some that support multi-channel surround sound. Some high-end headphones include technology that simulates surround sound, so sound effects feel like they’re coming from different directions. These headphones do a surprisingly good job at replicating the home theater experience and create an immersive experience for listeners. If you’re into big-budget blockbusters or first-person shooters and don’t have the room for a full-blown surround sound system, go for the next best thing and get headphones that support multi-channel audio.
That depends on what you’re using them for and how much you’re willing to spend. At the high-end, over-ear and in-ear headphones can both perform fantastically. For those of us not willing to spend thousands on headphones, over-ear headphones typically offer better bass response and a bigger soundstage, but in-ear headphones are significantly more portable and convenient — especially wireless earbuds.
Communication headsets are used for two-way communication and typically consist of a headphone and attached microphone. Such headsets are used in a variety of professions as aviation, military, sports, music, and many service-oriented sectors. They come in all shapes and sizes, depending on use, required noise attenuation, and fidelity of communication needed.
Expensive: Audiophile-grade headphones can cost anywhere between $130 and $2,000. Headphones in this price bracket are no joke: they create impressive soundscapes, are robust enough for use in a recording studio, and they’re just plain beautiful. If you need a pair of headphones for critical listening, or you simply want the best headphones around, it’ll cost you.

One thing I suggest to prospective customers for a specific headphone, if I have that headphone on hand, is for them to suggest 2 or 3 music tracks by a particular artist and composer that I can sample on that headphone, not so much for me to suggest how it sounds, but mostly to check if that headphone has any real sonic issues with that music. For example, a headphone that’s ideal for classical and acoustic music might sound too harsh with metal and industrial goth.


Technology has changed our lives in some pretty big ways – nowadays, it’s hard to imagine leaving the house without at least a few of our most important gadgets. New tech categories are sprouting up out of nowhere; ten years ago, no one had ever heard of a smartwatch, and now you see them everywhere you go. But there’s one tech category that’s remained essential all along: headphones.

If you’ve been on an airplane in the last few years, you’ve probably seen the Bose QuietComfort noise-cancelling headphones before: they’re a favorite of regular travelers because they’re so good at keeping outside noise out. They’re comfortable, they sound incredible, and the noise cancellation is so impressive that you feel like you’re in your own personal bubble. These headphones are not cheap, but they’re definitely worth the money.
For older models of telephones, the headset microphone impedance is different from that of the original handset, requiring a telephone amplifier for the telephone headset. A telephone amplifier provides basic pin-alignment similar to a telephone headset adaptor, but it also offers sound amplification for the microphone as well as the loudspeakers. Most models of telephone amplifiers offer volume control for loudspeaker as well as microphone, mute function and switching between headset and handset. Telephone amplifiers are powered by batteries or AC adaptors.
A: What you plug your headphones into can significantly affect their sound, and the quality of the amplifiers built into portable CD/MP3 players is generally awful. It's not their fault: the little guys have to power their electronics and their internal amplifier using a few puny volts. Even some of the better home AV receivers' headphone jacks offer highly variable sound quality.
A good headphone should last 25 years. The first thing to replace is earpads usually, since wear affects the sound. Sometimes the cable will get a loose connection and need replaced. The drivers should be good forever, but in some rare cases a hair can work its way in and cause a buzz or rattle. If that happens it’s usually easy to remove an earpad and pull the hair etc. out.
Passive noise isolation is essentially using the body of the earphone, either over or in the ear, as a passive earplug that simply blocks out sound. The headphone types that provide most attenuation are in-ear canal headphones and closed-back headphones, both circumaural and supra aural. Open-back and earbud headphones provide some passive noise isolation, but much less than the others. Typical closed-back headphones block 8 to 12 dB, and in-ears anywhere from 10 to 15 dB. Some models have been specifically designed for drummers to facilitate the drummer monitoring the recorded sound while reducing sound directly from the drums as much as possible. Such headphones claim to reduce ambient noise by around 25 dB.
While Apple’s AirPods get a lot of attention for how well they work with other Apple products, there’s actually a more affordable option that’s just as tightly integrated: the Beats BeatsX Earphones. Apple owns the Beats brand, and it’s built the BeatsX earphones with the same W1 chip that’s in the AirPods. That means that the user experience is virtually identical – iOS makes it super easy to pair them with any iPhone or iPad. Our favorite part is they have a Fast Fuel feature, so when your battery is low, plugging them in for five minutes provides two hours of talk time. We’re also big fans of the COWIN E7 Headphones. They’re wireless, they’ve got on-board noise cancellation, and they can last up to 30 hours on a single charge. The E7’s have an impressive spec sheet for any price point, but the fact that they’re so affordable makes them an even better value. If you’re looking for affordable over-the-ear headphones that don’t make any compromises, this is the pair to get.

Gaming headsets are headphones that have a microphone attached and allow users to speak to other people and hear them with the same device. In fact, gaming headsets have other practical applications as well. You can use them in business or personal situations when you want to speak to people on a computer using a video phone program or social media chat room. Although these work for music applications, they're more suited for conversational clarity.
×